QUICK FEEDERS must be mounted within a safe, dry,
covered area. DO NOT attempt to make modifications or changes to this
product or warranty may be nullified and voided.
INSTALLATION: Locate your new feeder close to a 110-volt receptacle for
electric power. Mount feeder on a suitable outer stall wall OUT OF THE
ANIMALS REACH for horses and other grain fed animals.
See Figures A, B
or C for mounting applications for your animal or pet. Note: Wall must
be solid and sturdy.
Determine a mounting height that allows the PVC pipe to be directed back
through the stall wall into the feed bucket as in Figure A (feed bucket
height may need to be lowered to accommodate ease in refilling the QUICK
FEED hopper).
For domestic pets, install feeder according to Figs A, B,
or C.
For all applications locate top center mounting hole on back of hopper and
mark wall. Install screw, hang feeder on single screw, level unit and
mark remaining 3 mounting holes. Install all 4 screws using washers;
tighten screws firmly.
Figure A
Typical Outer Stall Installation: Slip PVC 45� ell (do not
glue) over the spout adapter. Determine where the PVC pipe will penetrate
the stall wall and mark. Cut hole through stall wall . Insert PVC
through hole and into PVC 45� ell. Mark and cut off excess PVC pipe to
correct length. CAUTION: Do not leave PVC pipe protruding inside stall or
feed bucket where the animal can reach it. Cut flush with inside wall.
Figures B & C
Figures B & C - Direct Drop Installation: After hanging
feeder slip coupler over spout adapter. Determine length for PVC
pipe and cut to size. Slip PVC 45 ell over end if desired, slip pipe
into coupler.
